Doing some experiments on the extruder assembly for the 3D-printer. In this episode I focus on the Clay Container part of he extruder. Since this is “controlled” by air pressure it needs to be pressure tested and have a good seal #clay3dprinter #diy3dprinter #3dprint
.:| Air parts and Pressure Container |:.
PVC Pipe 4 inch:
https://ebay.to/2LbTapI
.:| Electronics and control |:.
Nema 42 Planetary Reduction Gear selectable Ratio:
http://bit.ly/2H4RuMw
Nema 17 Extruder Gear Stepper Motor Selectable Ratio:
http://bit.ly/2Kzc4Xn
Rampas 1.4 Controller + Mega2560 R3 + 12864 Display with Limit Switch & A4988 Stepper Motor Driver:
http://bit.ly/33DiEUe
Nema17 59Ncm 2A 1.8°4-lead 48mm:
http://bit.ly/2z1RKHG
.:| Aluminium Extrusions |:.
Machifit BLACK 2020 V-Slot Aluminum Profile Extrusion:
http://bit.ly/2YRFDw6
Machifit SILVER 2020 V-Slot Aluminum Profile Extrusion:
http://bit.ly/2KLqVNl
Machifit BLACK 2040 V-Slot Aluminum Profile Extrusion:
https://bit.ly/2WplCuO
Machifit SILVER 2040 V-Slot Aluminum Profile Extrusion:
http://bit.ly/302uLs4
Machifit Black 2060 V-Slot Aluminum Profile Extrusion:
https://bit.ly/2HyPFbw
Machifit SILVER 2060 V-Slot Aluminum Profile Extrusion:
http://bit.ly/31HCKep
Machifit Black 2080 V-Slot Aluminum Profile Extrusion:
https://bit.ly/2wfmp2Y
Machifit SILVER 2080 V-Slot Aluminum Profile Extrusion:
http://bit.ly/33zQn11
.:| Aluminium Profile Accessories |:.
Machifit 2020L L Shape Corner Connector:
https://bit.ly/2HxbQyA
Drillpro 50pcs M5 T Sliding Nut Aluminum Profile:
https://bit.ly/2Hxr1YC
Machifit Aluminium Angle Corner Joint 90 Degree Corner Bracket:
https://bit.ly/2JWEL0M
Machifit 5 Holes Aluminum Profile Corner Bracket 90 Degree:
https://bit.ly/2JXBdLz
Inside Corner Connector Joint Bracket for Aluminum Profile:
https://bit.ly/2JA1osy
.:| Aluminium plates |:.
300x100x6mm ALUMINUM 6061 Flat Bar:
https://ebay.to/2N0XhXn
Music:
https://www.epidemicsound.com/
Community:
Website: https://goo.gl/9wZcs1
Instagram: https://goo.gl/1TnxKW
Facebook: https://goo.gl/H7L72E
Patreon: https://goo.gl/5pm5qs
Twitter: https://goo.gl/fzWWcA
One thought on “DIY Ceramics 3D Printer (part 2A) – Extruder Experiments | Clay Container | AIR”