Homemade table saw (Part 5) – Extension TABLE | CNC Feet | Adjustable FEET

I make an extension on my home made table saw

.:| Router guide diagram i used |:.

http://www.willysgaragenorway.no
http://willysgaragenorway.no/tsr4measurements/

.:| Products used in this project |:.

T-track t-slot 800mm:
https://www.banggood.com/custlink/DGvvIIWekI
Machifit 10pcs M6 T Slot Nut T-Track:
https://www.banggood.com/custlink/m3GvZ8WAtG
Machifit 10pcs M8 T Slot Nut T-Track:
https://www.banggood.com/custlink/KmKvZSrsPF
1/2 Inch (12.8mm) Straight Dual Edged Cutter Router Bit:
https://www.banggood.com/custlink/3DmDISWNtM

.:| Other products used in this project |:.

Pocket hole jig:
https://www.banggood.com/custlink/GmGmHKLrbP
90 Degree Right Angle Clip:
https://www.banggood.com/custlink/KKKKVGLcs4
12inch Triangle Square Tool:
https://www.banggood.com/custlink/D3D3VGorQM
16pcs 15-35mm Forstner Drill Bit Set:
https://www.banggood.com/custlink/mGKvV3jJnf

Music:
https://www.epidemicsound.com/

Community:
Website: https://goo.gl/9wZcs1
Instagram: https://goo.gl/1TnxKW
Facebook: https://goo.gl/H7L72E
Patreon: https://goo.gl/5pm5qs
Twitter: https://goo.gl/fzWWcA

Leave a comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.