Making TOOLPATHS and exporting G-CODES | Fusion 360



I try to explain how to make toolpaths and exporting them as gcodes from Autodesk Fusion 360. This makes it possible to use the g-code files in other controller software like Chillipeppr and Universal G-code Sender (UGS). I personally use the UGS Platform software to send the g code to the Arduino UNO and then to the TB6560 (TB6000)

Community:
https://www.instagram.com/willysgaragenorway/
https://www.facebook.com/willysgaragenorway
https://twitter.com/WillysGNorway
https://www.patreon.com/WillysGarageNorway



Leave a comment

Your email address will not be published. Required fields are marked *