First DIY CNC build (part 11) – CABLE DRAG chains and WIRING stepper motors


It’s time to wire up the stepper motors permanently and mounting the plastic cable drag chain on all the axis of the CNC machine. I’m using shielded cables and Ferrite Beads to counteract the electronic noise from the steppers and the spindle.

Materials used in this project:
SBR12-600mm-Linear-Rail:
https://goo.gl/U63i5a
4pcs Aluminum Flexible Shaft Coupling 5mm x 8mm:
https://goo.gl/FT9zCb
CNC 500W Spindle Motor with 52mm Clamps and Power Supply:
https://goo.gl/s3Pi7h
Nema17:
https://goo.gl/kPcpgD
CNC Shield V3 3D Printer and 4xA4988 Driver and Arduino UNO w/USB Cable:
https://goo.gl/LGM36v
5pcs a4988 stepper motor driver:
https://goo.gl/N7eeW2
600mmrail:
https://goo.gl/xxnFwi
linear bearings:
https://goo.gl/dJjMgH
Nema17:
https://goo.gl/FxLB38
5pcs a4988 stepper motor driver:
https://goo.gl/N7eeW2
NEMA23 2.8A:
https://goo.gl/vNeica
3pcs TB6560 3A Stepper Motor Drivers:
https://goo.gl/N9qZhK
24V 14.6A Power Supply For CNC and 3D-printers:
https://goo.gl/mL83ah
CNC Shield V3 3D Printer and 4xA4988 Driver and Arduino UNO w/USB Cable:
https://goo.gl/LGM36v

 



Community:
Website: https://goo.gl/9wZcs1
Instagram: https://goo.gl/1TnxKW
Facebook: https://goo.gl/H7L72E
Patreon: https://goo.gl/5pm5qs
Twitter: https://goo.gl/fzWWcA

Leave a comment

Your email address will not be published. Required fields are marked *